How To Use Flood Protection^™ Starter Kit

For complete instructions go to: flexsealproducts.com/flood

Read entire label for directions and warnings before use.

• Protective gloves, clothing, and eyewear are recommended.

• Apply to the exterior of the structure.

• Area being sealed must be clean, dry, and free of grease, oil, and dirt.

Flood Protection Paste

• Unscrew nozzle, cut the nub on the cartridge, being careful not cut or damage threads.

• Screw nozzle back on cartridge and cut nozzle to the desired thickness of the bead.

• Place the cartridge into the caulking gun.

• Using a smooth motion, apply an even bead directly to the areas being sealed.

• Use your finger or tool to push the bead into the surface being sealed (gloves recommended).

• Apply additional coats after 2-6 hours or when dry to the touch.

• Additional coats should overlap and be wider than previous coats.

• Material can be tooled for approximately 10 to 15 minutes before curing begins.

• Allow approximately 24 to 48 hours to fully cure before floodwaters arrive.

Flood Protection Liquid

• Stir well before use, do not shake.

• Brush, roll, or pour several even coats anywhere water may enter.

• Apply additional coats after 3-6 hours or when dry to the touch.

• Additional coats should overlap and be wider than previous coats.

• Allow approximately 24 to 48 hours to fully cure before floodwaters arrive.

REMOVAL

Grab a small portion of material from an edge and pull away from the structure. Using a small pair of pliers may be necessary. If any residue is left on the surface, use a stiff nylon brush, paper towel or rag with denatured alcohol to clean the area.